Controlant CO 01.01 User's Guide Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 10
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
6
LEDs, Buttons and Connectors
Figure 2: LED, On/Off switch and DC power connector for the CO 01.01 transceiver.
Connection and power-on
1. Connect the DC plug of the external power supply to the DC power inlet.
2. Turn on the power switch.
3. Wait for the LED indicator light to indicate full operation.
LED indicator light
A green LED indicates the status of the transceiver.
Indications:
On/Off
Status of external power
On-line connection status
LED status
Status
Off
The transceiver is turned off, or is not operating. (Note that if the
internal battery is empty the transceiver may take up to 20 minutes
to reach the charge necessary to operate the system)
Off, blinking every 0.5
seconds
Operating on battery. The local network is up and running. No
connection to central database.
Off, blinking every 2 seconds
Operating on battery. The local network is up and running.
Initializing connection to central database.(Note that more than 4
minutes in this mode might indicate a failure in GPRS connection)
Off, blinking every 4 seconds
Operating on battery. The local network is up and running.
Data is being transferred to the central database.
On, blinking every 0.5 seconds
Charging mode. The transceiver is connected to a power source and
is being charged. The local network is up and running. No connection
to central database.
On, blinking every 2 seconds
Charging mode. The transceiver is connected to a power source and
is being charged. The local network is up and running. Initializing
connection to central database.(Note that more than 4 minutes in
this mode might indicate a failure in GPRS connection)
On, blinking every 5 seconds
Charging mode. The transceiver is connected to a power source and
is being charged. The local network is up and running. Data is being
transferred to the central database.
On/Off Switch
The power switch has two purposes, to set the transceiver into hibernation mode and to do a full reset. The
power switch does not physically disconnect the device from the power source.
Page view 5
1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments